Straight lipped heatshrink boots from Glenair are used for the attachment to standard circular connector adaptors. Once the boot has been shrunk, the lip locks into the adaptor groove. The eyelet hole allows for the attachment of dust caps or protective covers. The heatshrink boot size is based on adaptor diameter and cable diameter.
Type 1 high performance elastomer lipped straight heatshrink boot is a semi rigid boot that performs at extreme temperatures and has excellent resistance to fuels, oils and solvents. Operating temperature from -75º to +150ºC. The heatshrink boot material meets the requirements of VG95343 Type 6, BSG 198-5-DE, EN62329-102 and SAE AS5258 Type H. These boots fit most standard boot adaptors for circular connectors and are suitable for military vehicles, petrochemical exploration and other demanding environments.
Type 2 zero halogen lipped straight heatshrink boot is a semi rigid, flame retardant polyolefin boot that is used where limited fire hazards exists. With good resistance to oils, fuels and solvents, the low smoke zero halogen (LSZH) heatshrink boot fits most standard adapters that include M85049 and material meets the requirements of NAVSEA 5617649, VG95343 Part 29, BSG 198-5-DF, EN62329-101 and SAE AS5258 Type G. These boots provide strain relief and environmental protection to connector/ cable transitions.
Type 3 polyolefin, flexible lipped straight heatshrink boot is an economical, general-purpose boot for use where occasional exposure to heat and chemicals may occur. These self-extinguishing boots have a good resistance to oils and fuels and are available with optional hot melt adhesive lining. Providing strain relief and environmental protection to connector/ cable transitions, the polyolefin boots meet the requirements of SAE AS81765/1 Type II. |
